Видео

One is Armstrong and the USG

Actually... Good marketing strategy 😂

Was so worried about finger being cut, had to watch twice 😂

Thanku sir

Thanks. I have a 1980's ceiling that I don't want to have to completely redo to convert from 2 x 4 to 2 x 2. Now I just need stronger hands!

Excellent ❤

Bro u save my day ❤

Great ending!

Thanks, that was very helpful.

Definitely incorrect,center between the slots,once the tab is created separate the tab and cut one side off so its easy to rivet together once you've opened up other cut main.

Are you scared to cut with your snips or something?

What the F is that?

Seems like a design flaw if you have to modify them to function

This is not how you do it but anyways

Screw's will damage the tile use a pop rivet

I need work I have 6 years experience

I have 6 years experience

Please don’t field splice likes this. Now you have a slot right at the joint. Measure back 3 inches from slot use a pocket square mark it, cut it. open the inside up feed new main into cut one. Then you have 6” increments. Squeeze it back together, punch a hole and put pop rivet in it.

If the center's for the tee bars are out afew mil it will stand out like dogs balls

But why? Too much cutting. Measure 3" from slot, stab it into the other main runner, Bing Bang Boom.

👍👍

nice sir

Hi. What companies selling suspended ceiling ? What would you recommend instead of suspended ceiling for kitchen ? Many thanks

I just like to cut the main halfway between the slots then slide the new main tab in the same way you made yours but use the factory tab instead.

Nope you cut one at three inches from the slot than plug in the other main and pop it

This is not soundproofing but sound treatment

So glad you did pt 2 thanks

You still use it?

Pretty Kool thats one way of doing it . But still there's 2 easier ways to do it as well

Thank you ।

excelent i have been looking for this

Hi there I was wondering if you could give me some information ,,, if a room is 7 metre in length and 5 meters in width with my full tiles dropped in length ways gives me 6.6 metres with a 200mm rip either end then width ways gives me 4.8 with my tiles dropped in leaving a 100mm rip each side , is there any way to get that perimeter equal on both length and width ways or do I just go with the 200mm rip on the length and 100mm rip on the width and no other way to go about it , thanks

Is that an approved method?

Thank You, helped me out big time!

DUDE ONLY CUT 1 OF THE MAINS MEASURE BACK 3 INCHES FROM SLOT CUT IT ////THEN OPEN IT UP AND THEN PUT THE OTHER MAIN WITH THE TAP INTO IT THERES YOUR 6 INCHES

Why would you do that if you already have the link tabs?

Thank u🤗

The problem with using a screw is that it will stick out the other side. Solution- use a pop rivet instead

Thanks for the video helped me out perfect!!!👍🏻

Wow thanks for the video!! It’s perfect!!!!👍🏻👍🏻

Lol

Thanks. Great video.

Dude you didn't show the bottom

You should link part 2 to this.

I took down a closet and need to extend the runners to the wall. This is perfect.

Amaizing It was super helpful I just learned from this video Thank you!!!

Great work! Keep it up

Why did you snip that bottom piece! Can you talk! SMH!

excellent!

Thanks